DonJoy Tru-Pull Attachment

APPLICATION INFORMATION :

1) PARTS: (A) One Tru-Pull Advanced Attachment, (B) one buttress, (C) two buttons, (D) one double sided patch, (E) two adhesive patches, (F) two screws, (G) two washers.

2a)  REMOVE: Remove lateral (the outside of brace) condyle pad.

2b)  THIGH AND CALF FRAME LINER: Peel back thigh and calf

frame liner on inside of brace’s medial side.

Note: Arrow indicates medial jog (bend on the inside of

the brace).

3)  Peel off backing and apply button to frame approximately halfway between the straps at thigh and calf sections on medial side of brace.
Note: Button to face outside of frame. See Figure 3. APPLY (2) BUTTONS: Apply buttons to the brace wrapping button flaps tight around the frame to meet or overlap on the inside of the brace under the liner as shown in Figure 3. RE-ATTACH : Place the thigh and calf liners back in place. Note: If necessary apply additional adhesive patch to hold liner in place.

4)  For Standard hinges: Slide Tru-Pull Advanced Attachment over the plastic condyle shell (from back of the brace toward the front) where the condyle pad was removed.

5)  For LoPro Fourcepoint hinges: Place washers and screws on the soft side of the inner flap. The screw should go through the soft-side first and the plastic piece second. Be sure to align the holes from the flap on to the threaded holes of the hinge. See figure 5A. Then screw in the screws to the threaded holes. See figure 5B.

6)  RE-APPLY: If necessary reapply both condyle pads using double sided patch to secure it to the Tru-Pull Advanced Attachment as shown in Figure 6.
Note: Various thicknesses of condyle pads can be used to improve comfort and fit. APPLY: Buttress to the inside of tru-pull advanced attachment as shown to fit snugly against the lateral side of the patella.

7)  APPLY: Adjust button hole slots to frame buttons to the desired tension. trim excess material from the ends of the straps. see figure 7.
Note: to trim strap ends cut with scissors in-between the stitched seams.